Skip to Content
A galvanized process plant structure with silos, walkways and access platforms.

Water treatment

Silo and Hopper Fabrication

South Coast Iron fabricates silos and hoppers in stainless and carbon steel for the waste water treatment industry, and installs them. We build them in one piece in our Placentia shop where the site allows, or in the largest sections that can be shipped and erected in the field.

  • Metal Fabrication
  • Structural Steel
  • Custom Fabrication
  • Access & Safety Systems
  • Silos & Hoppers
  • Laser Cutting

At a glance

Specifications

Capacities are our own machines. Sizes and wall thicknesses are set by your drawings.

MaterialsStainless steel and carbon steel
Supplied asComplete, or sectioned for field erection
InstallationAvailable, including coordination where we do not install
IndustryWaste water treatment
Plate cuttingUp to 1½ in on the 20 kW sheet laser
DetailingIn house, SolidWorks

What we cover

  • Stainless and carbon steel
  • Complete units, or sectioned for shipping and field erection
  • Installation available, and coordination offered either way
  • Built alongside the platforms and access steel that go with them
Structural steel conveyor framing at a process plant.

Built in sections, not as a kit of parts

The usual way this goes wrong is that a manufacturer ships what amounts to a parts kit, and the field crew is left to work out how it goes together. Sean calls it an erector set. Hours get spent on site that should have been spent in a shop, and anything that does not fit becomes an expensive problem a long way from a welding bay.

We work with the manufacturer and with the contractor or end user both, so the thing arrives in the biggest pieces the job can actually take. Fewer field joints, less fit-up, less time on the structure. We do this even where we are not the ones installing, because an install that goes badly reflects on the steel whoever bolted it together.

A large fabricated steel hopper positioned on site.

Cut on the laser, not traced by hand

Shells, cones, gussets and flanges are cut on our own sheet and tube lasers rather than marked out and flame cut. That matters most on a cone, where a small error in the developed flat pattern turns into a seam that will not close. Parts are detailed and programmed in house in SolidWorks, so the flat pattern and the fabrication drawing come from the same model.

Placentia, California

From the shop

A fabricated cone section being lifted by crane outside the shop.
The bolted corner of a fabricated steel hopper section.

Before you call

Questions we get asked

Not answered here? The fastest route is a phone call to the shop.

Got a drawing? Talk to the shop.

Call and we will talk it through, or send the scope and drawing set and we will get back to you with pricing and a schedule.