Skip to Content
An elevated steel hopper structure with supporting legs.

An industry we know

Water Treatment Steel Fabrication

South Coast Iron fabricates stainless and carbon steel silos, hoppers, platforms, walkways and access systems for water and waste water treatment, from Placentia, California. We build in the largest sections a site can take, which is what makes installation go well.

  • Metal Fabrication
  • Structural Steel
  • Custom Fabrication
  • Access & Safety Systems
  • Silos & Hoppers
  • Laser Cutting

At a glance

Specifications

EquipmentSilos, hoppers, chutes, tanks, equipment supports
AccessPlatforms, walkways, stairs, ladders, guardrail
MaterialsStainless, carbon steel, galvanized, aluminum
AssemblyOne piece or large sections, field erection available
Field measurementTrimble X9 LiDAR scanning
ComplianceOSHA access and fall protection

What we cover

  • Stainless and carbon steel silos and hoppers
  • Walkways, catwalks and equipment platforms
  • Aluminum and galvanized stairs and ladder access
  • OSHA guardrail, toe board and safety gates
  • Built in one piece or in large sections, installation available
A magnetic drill set up on a steel beam on the shop floor.

The erector set problem

The pattern we see constantly in this industry is a manufacturer shipping what amounts to a parts kit, or as we call it an erector set, for a field crew to work out on site. Every joint becomes a decision made by someone standing in the weather with a schedule to hit.

We work with the manufacturer and the contractor or end user together so the equipment arrives in bigger sections, or in one piece where the site can take it. Fewer field joints means faster installation, fewer errors and less rework. We do this even when we are not the ones contracted to install.

The web and flange of a fabricated girder, holes punched to pattern.

Material chosen for the chemistry

Treatment plants are a hostile environment and the wrong material choice is expensive in a way that only becomes obvious in year three. Galvanized steel gets attacked, coatings fail, and recoating an installed walkway over an open channel is work nobody wants to budget for.

Stainless and aluminum cost more at purchase and frequently cost far less across the life of the asset. We fabricate all three, so we have no incentive to steer you. Tell us the chemistry and the exposure and we will give you the honest comparison.

A steel plate stamped with its heat number for traceability.

Scan the plant rather than measuring it

Retrofit work in a live plant is where field measurement usually falls apart. Access is restricted, the shutdown window is short, and nobody wants to go back three times with a tape.

We scan with a Trimble X9 LiDAR, typically in about twenty minutes for a defined area, and detail from the model. Parts fit the first time, which matters most when the shutdown window is the constraint.

Before you call

Questions we get asked

Not answered here? The fastest route is a phone call to the shop.

Got a drawing? Talk to the shop.

Call and we will talk it through, or send the scope and drawing set and we will get back to you with pricing and a schedule.