Skip to Content
Metal roof decking laid across structural framing.

Cut, banded, delivered

Steel Grating and Metal Decking

South Coast Iron supplies, cuts, bands and installs steel grating, stair treads and metal decking from Placentia, California. We cut openings and penetrations to your drawings rather than leaving them to be hacked out on site.

  • Metal Fabrication
  • Structural Steel
  • Custom Fabrication
  • Access & Safety Systems
  • Silos & Hoppers
  • Laser Cutting

At a glance

Specifications

TypesWelded bar, press locked, checker plate, smooth plate
MaterialsCarbon steel, galvanized, stainless, aluminum
FabricationCut, banded, mitred, stair treads with nosing
OpeningsPenetrations cut and banded to drawing in the shop
ComplianceDetailed to OSHA walkway requirements
InstallationAvailable across Southern California

What we cover

  • Welded and press locked bar grating
  • Grating stair treads with nosing
  • Checker plate and smooth plate decking
  • Banded openings and penetrations cut to drawing
  • Galvanized, painted, stainless and aluminum
Metal decking installed over a steel frame.

Site cut grating is a false economy

Grating cut on site is cut with an abrasive wheel by someone standing on a walkway. The edges are rough, the cut bars are unsupported unless they are banded, and banding on site rarely happens properly.

Cut in the shop to a drawing, every opening comes out square, every edge is banded, and the installation crew is bolting panels down instead of fabricating. The labor saving usually exceeds the fabrication cost, and the result is safer.

Interior structural steel roof framing and decking.

Get the penetrations on the drawing

The single most common cause of grating rework is a penetration that nobody told the fabricator about. A pipe, a conduit, an equipment leg, a hand hole. They are easy to cut and band in the shop and genuinely awkward on an installed walkway.

If you can give us a layout with the penetrations marked, we will deliver panels that drop in. If you cannot, tell us and we will plan for site adjustment honestly rather than pretending it will not be needed.

A row of studs welded to a steel plate at even spacing.

Specify the load, not just the size

Grating is chosen by span and load, and the two go together. A panel that is fine as a maintenance walkway may not be fine as a forklift crossing or under a point load from equipment.

Tell us the span, the load and whether anything will be wheeled across it. That takes one sentence and it removes most of the risk of specifying the wrong bar depth.

Before you call

Questions we get asked

Not answered here? The fastest route is a phone call to the shop.

Got a drawing? Talk to the shop.

Call and we will talk it through, or send the scope and drawing set and we will get back to you with pricing and a schedule.