Skip to Content
A fabricator grinding a welded rail, sparks running off the wheel.

Under our own roof

Metal Polishing and Finishing

South Coast Iron polishes stainless steel, aluminum, bronze and copper in house at our Placentia, California shop. Most fabricators subcontract polishing. Keeping it here is what lets us match a finish across an entire assembly and hold a delivery date.

  • Metal Fabrication
  • Structural Steel
  • Custom Fabrication
  • Access & Safety Systems
  • Silos & Hoppers
  • Laser Cutting

At a glance

Specifications

MaterialsStainless, aluminum, bronze, copper
FinishesSatin, brushed, directional grain, mirror
ScopeWeld dressing, blending, polishing, touch up
MatchingTo sample, photograph or existing installation
LocationIn house at Placentia, CA
On site workTouch up and repair available

What we cover

  • Satin, brushed, directional grain and mirror
  • Stainless steel, aluminum, bronze and copper
  • Weld dressing and blending before finishing
  • Finish matching to an existing installation
  • Touch up and repair on installed work
A fabricator grinding a steel edge at the bench.

Subcontracted polishing is where schedules go wrong

A fabricator who sends work out for finishing has handed over the last step before delivery, and with it the schedule. The assembly is finished when the polisher gets to it, not when you need it. If a panel comes back a shade off the rest, it goes back in the queue again.

We kept polishing in house for exactly that reason. It means the person finishing a handrail can walk back to the person who welded it, and it means a late change does not cost a week.

A welder laying a bead, sparks and arc light against the shop wall.

Matching is harder than polishing

Producing a good finish on one piece is straightforward. Producing the same finish on twenty pieces, welded by different people on different days, is the actual job. Grain direction has to run the same way. Weld dressing has to be consistent before polishing starts, because a blended weld and a ground weld will never take the same finish.

That consistency comes from sequence and from the same shop controlling both steps. It is very difficult to buy from two suppliers.

A welder in an orange jacket welding a fabricated assembly.

Send a sample if you have one

The fastest way to get a finish right is to let us see the one you are matching. A photograph helps, an offcut helps far more, and an existing component is best of all.

If you are still at drawing stage, tell us the finish you want before the details are fixed. Some joints are easy to polish and some are close to impossible once they are welded, and knowing which is which early saves money.

Before you call

Questions we get asked

Not answered here? The fastest route is a phone call to the shop.

Got a drawing? Talk to the shop.

Call and we will talk it through, or send the scope and drawing set and we will get back to you with pricing and a schedule.